5. Specify IPv4 Address.
For details on how to specify the IPv4 address, see "Interface Settings", Network and System Settings
Guide.
6. Connect the machine to the network.
7. Start Web Image Monitor, and then log on to the machine as the administrator.
For details about logging on to Web Image Monitor as an administrator, see "Using Web Image
Monitor".
8. Install the device certificate.
For information on how to install the device certificate, see "Protection Using Encryption".
9. Enable secure sockets layer (SSL).
For details about enabling SSL, see "Protection Using Encryption".
10. Enter the administrator's user name and password.
For details about specifying the administrator user name and password, see "Registering the
Administrator".
The administrator's default account (user name: "admin"; password: blank) is unencrypted between
steps 6 to 9. If acquired during this time, this account information could be used to gain unauthorized
access to the machine over the network.
If you consider this risky, we recommend that you specify a temporary administrator password for
accessing Web Image Monitor for the first time, before connecting to the network in step 6.
• p.36 "Using Web Image Monitor"
• p.174 "Protection Using Encryption"
• p.30 "Registering the Administrator"
Setting Up the Machine
15
To Next Page
Loading...
Need help?
General
