If the target destination does not appear, take one of the following steps:
• Display the destination by selecting its initial letter from the title
• Display the destination by pressing [ ] or [ ]
• Depending on the security setting, some destinations may not appear in the destination list.
Selecting destinations by entering the registration numbers
Select the destination from the machine's address book using its registration number.
1. Press [Reg.No.] .
2. Enter the five-digit registration number that has been assigned to a destination folder using
the number keys.
If the entered number is less than five digits, press the [ ] key after the last number.
Example: To enter 00004
Press the [4] key, and then press the [ ] key.
By pressing [Change], you can change the selected destination.
3. Press [OK].
2. Sending Scan Files to Folders
64
To Next Page
Loading...
Need help?
General
