Switching to the WSD Scanner Screen
This section explains how to switch from the screen that is currently displayed to the WSD scanner screen.
When the E-mail screen, Scan to Folder screen, or network delivery screen is displayed, you can use the
following procedure to switch to the WSD scanner screen.
1. Press [Swtch Dest.List].
The [Switch Destination List] screen appears.
2. Press [WSD], and then press [OK].
The WSD scanner screen appears.
• You cannot switch the screen while e-mail or other destinations are being specified. To clear a
specified destination, display the destination in the destination field of each screen, and then
press the [Clear/Stop] key.
• If you are not using the network delivery function, [WSD Dest.] is displayed instead of [Swtch
Dest.List]. Press [WSD Dest.] to switch to the WSD scanner screen.
• [Swtch Dest.List] or [WSD Dest.] is displayed only when the WSD scanner function is set to [On]
using Web Image Monitor. For details about making this setting, see "Preparation for Sending
files Using WSD".
• p.78 "Preparation for Sending Files Using WSD"
Switching to the WSD Scanner Screen
85
To Next Page
Loading...
Need help?
General
