The printer driver with the selected language will be installed. The English printer driver is installed
when the following language is selected: Suomi, Magyar, Cestina, Polski, Portugues, Russian,
Catala, Turkce.
4. Click [PostScript 3 Printer Driver].
Add Printer Wizard starts.
5. Click [Local printer attached to this printer].
6. Click [Create a new port:].
7. Click [Standard TCP/IP Port] in [Create a new port], and then click [Next >].
8. Click [Next >] in the [Add Standard TCP/IP Printer Port Wizard] dialog box.
9. Enter the printer name or IP address in the [Printer Name or IP Address] box.
The [Port Name] text box automatically obtains a port name. Change this name if necessary.
When screen for Device selection appears, select “RICOH NetworkPrinter Driver C Model”.
10. Click [Next >].
11. Click [Finish] in the [Add Standard TCP/IP Printer Port Wizard] dialog box.
12. Check that the name of the machine whose driver you want to install is selected, and then
click [Next >].
13. Change the printer name if you want, and then click [Next >].
Select the [Yes] check box to configure the printer as default.
14. Specify whether or not to print a test page, and then click [Finish].
The printer driver installation starts.
• A user code can be set after the printer driver installation. For information about user code, see the
printer driver Help.
• Auto Run may not work with certain operating system settings. In that case, launch “Setup.exe” on
the CD-ROM root directory.
Using the Standard TCP/IP Port
25
To Next Page
Loading...
Need help?
General
