Ricoh D065 - Page 539

Service Program Mode Tables
D062/D063/D065/D066 4-6 SM Appendix
005
Center Lamp Temp (Small Size
Paper)
D062/D063/D065: [180 to 205/205/1 deg C]
D066: [175 to 190/190/1 deg C]
006
End Lamp Actual Time (Small
Size Paper)
D062/D063/D065: [0 to 120/60/1 sec.]
D066: [0 to 60/10/1 sec]
007 Center Lamp Temp (Thick Paper)
D062/D063/D065: [180 to 205/205/1 deg C]
D066: [175 to 200/200/1 deg C]
008
End Lamp Actual Time (Thick
Paper)
D062: [0 to 120/0/1 sec.]
D063/D065: [0 to 120/5/1 sec.]
D066: [0 to 120/10/1 sec.]
009
Japan only
Capacitator for Check Start
Fusing Temperature
C4c: [170 to 205/200/1 deg C]
010
Japan only
Capacitator for Check Start
Fusing Lamp ON Time
C4c: [0 to 120/0/1 sec.]
1109 Measure Nip Width
001 Execute 0 or 1
002 Adjust Value
[200 to 400/300/10mm]
1112 Hot Roller Temperature for Auto Process Control
001
Sets the temperature of the hot roller for auto process control to start.
[70 to 150/140/1°C] DFU
1159 Fusing Jam: SC Setting
001
This SP determines what the machine does if paper jams occur in the fusing unit
for three consecutive sheets of paper.
0: (default): A jam alert is shown on the screen. The customer can remove the
jam and the machine works normally after that.