Risco ProSYS Plus - Page 96

11
/
2017 Page 96 5IN2413 B
System  Controls  Device
Quick keys Parameter Default Range

Device
This section refers to controls that apply to bus devices
 
Anti Mask = Tamper
No Yes/No
Used to determine the operation of anti-masking detection in a bus zone.
YES: Anti mask violation will activate tamper alarm.
NO: Anti mask violation will be regarded as trouble event.
 
Proximity Anti Mask
=Tamper
No Yes/No
Used to determine the operation of the proximity anti masking detection
indicated by the microwave channel in the WatchOUT DT detector.
YES: Proximity anti mask detection will activate the tamper alarm.
NO: Proximity anti mask detection will be regarded as a fault event.
Notes
• The Proximity Anti Mask operates for approximately 2.2 seconds when
the detector is approached in close proximity.
• Ensure that Proximity Anti Mask has been enabled when configuring the
WatchOUT DT bus zone parameters.
 
Audible Proximity
Tamper
No Yes/No
This parameter relates to the bus siren.
YES: A proximity anti approach violation will activate the siren.
NO: A proximity anti approach violation will not activate the siren and will
be regarded as trouble by the system.
 
Siren Auxiliary =
Tamper
No Yes/No
This parameter relates to the bus siren.
YES: A siren auxiliary trouble will be regarded as tamper alarm by the
system.
NO: A siren auxiliary trouble will be regarded as trouble by the system.

RF Wake-Up
No Yes/No
Toggle between Y (yes) and N (no) to define whether the system can wake
up the 2-way wireless Slim keypad during exit/entry times, or when failing
to arm the system.
YES: The system wakes up the keypad.
NO: The system cannot wake up a 2-way keypad (this saves battery life).