Advanced Features
Changing Default Settings [Admin.]
174
[Default]
Reproduction Size
Change the default setting for the “size”.
100%
, Auto
Print Speed
Change the default setting for the “print speed”.
1, 2, 3
,4 ,5
Print Density
Change the default setting for the “print density”.
Print Drum 1: 1, 2, 3
,4 ,5
Print Drum 2: 1, 2, 3
,4 ,5
Scanning Side -ADF
If the machine is equipped with the optional Auto
Document Feeder DX-1, select the default scanning
side for simplex original using “Scanning Side -ADF”.
)p.164
Front Side
, Back Side
OP Auto Process
Change the default setting for the “Auto Process” when
an optional ADF unit or Job Separator is installed.
ON
, OFF
ADF Semi-Auto
Change the default setting for the “ADF Semi-Auto”
when the ADF unit (option) is installed.
ON, OFF
Auto Process Mode
Change the default setting for the “Auto Process”.
ON, OFF
Double Feed Check
Change the default setting for the “
Double Feed Check
”.
ON, OFF
Job Separation
Change the default setting for the “Job Separation”
when the Job Separator (option) is installed.
ON, OFF
Eject Wing Control
Change the default positioning of the Paper Ejection Wing.
Important!:
• This option is available only when the special paper
setting is pre-configured. Contact your dealer (or
authorised service representative) to pre-configure
this setting.
ON, OFF
Paper Ejection Adj
Change the default settings for “Air Blow” and
“Separation Fan”.
Air Blow 1: OFF, ON
Air Blow 2: OFF
, ON
Separation Fan 1: OFF, 1, 2, 3, 4
Separation Fan 2: OFF, 1, 2, 3, 4
Default Folder
Specifies the folder in which to save the data read in
scanner mode and the folder to save the data sent
from the computer.
Scan Data Folder: 6 folders
PC Job Folder: 6 folders
Display Access
Button
Functions Description
To Next Page
Loading...
