Riso MZ970 - Setting up the Paper Feed Tray and Loading Paper

Basic Operations
Preparing to Print
33
Setting up the Paper Feed Tray and Loading Paper
Important!:
• Do not use unsuitable paper, or mix paper of different sizes.
Doing so can cause paper jams and damage the machine.
)p.14
1
Open the Paper Feed Tray.
Pull the Paper Feed Tray to open until it comes to
a rest.
2
Load paper.
1) Place paper in the printing orientation.
2) Slide the Feed Tray Paper Guides to fit to the
sides of the paper. Then turn the right and left
Feed Tray Paper Guide Levers to lock the
guides.
: Unlock
: Lock
Important!:
• Make sure that the Feed Tray Paper Guides fit
tight up against the paper.
Failure to do so can produce undesired results.
Note:
• Custom size paper must be registered on the
Admin. screen before use.
)p.186
Failure to do so may create an incomplete mas-
ter.
3
Select the paper feed pressure.
Position the Paper Feed Pressure Adjustment
Lever according to the finish of the paper.
: For standard paper
: For thick or smooth-surface paper
4
Check the Basic Screen.
Note:
• Paper size is automatically detected. When
size display shows “Custom”, custom size
paper is loaded, or Feed Tray Paper Guides are
not properly set against the paper.
Make sure that the paper fits tightly against the
Feed Tray Paper Guides. When using custom-
sized paper, touch [Paper] and select the size.
)p.82