Rohde & Schwarz RTB2004 - Page 348

Fernsteuerbefehle
R&S
®
RTB2000
348Bedienhandbuch 1333.1611.03 ─ 05
Parameter:
<Type> HORizontal | VERTical | HVERtical
To set the V-marker measurement, use CURSor<m>:
TRACking[:STATe].
*RST: VERTical
Value Description Queries for results
HORizontal Sets two horizontal cursor lines and measures the
voltages at the two cursor positions and the delta
of the two values.
CURSor<m>:Y1Position
CURSor<m>:Y2Position
CURSor<m>:YDELta[:VALue]?
CURSor<m>:YDELta:SLOPe?
VERTical Sets two vertical cursor lines and measures the
time from the trigger point to each cursor, the time
between the two cursors and the frequency calcu-
lated from that time.
CURSor<m>:X1Position
CURSor<m>:X2Position
CURSor<m>:XDELta[:VALue]?
CURSor<m>:XDELta:INVerse?
HVERtical Combines the HORizontal cursor and VERTical
cursor measurements. Two horizontal and two ver-
tical cursor lines are set and the voltages and time
from the trigger point are measured at the cursor
positions, as well as the delta of the voltage and
time values.
CURSor<m>:Y1Position
CURSor<m>:Y2Position
CURSor<m>:YDELta[:VALue]?
CURSor<m>:X1Position
CURSor<m>:X2Position
CURSor<m>:XDELta[:VALue]?
CURSor<m>:TRACking[:STATe] <State>
If set to ON, the V-Marker cursor measurement is enabled.
Suffix:
<m>
.
1, the suffix is irrelevant.
Parameter:
<State> ON | OFF
*RST: OFF
CURSor<m>:X1Position <Xposition1>
CURSor<m>:X2Position <Xposition2>
The commands specify or return the positions of vertical cursor lines on the x-axis
(time, frequency for FFT).
Suffix:
<m>
.
1, the suffix is irrelevant.
Parameter:
<Xposition1>
<Xposition2>
Bereich: Depends on the current instrument settings, for
example, horizontal position.
Std.-einheit: s
Messungen