Rotax 914 F - Page 75

Reference
Modification no.
- 0 -
Page
75
Date
1997 02 01
Main
914 F
01476
46 877 580 pull-in spindle M24x1,5 .......................................................1
47 276 155 handle 12x250 ....................................................................1
48 842 585 hex. nut M24x1,5 length 19 .................................................1
49 941 180 stud M10x45/20...................................................................1
for roller bearing 25x52x15 and oil seal 30x52x7
50 877 605 protection piece...................................................................1
for propeller shaft F2
51 877 600 protection piece...................................................................1
for propeller shaft F3 and F4
52 877 592 protection piece...................................................................1
for roller bearing 25x52x15 and oil seal 30x52x7, for F2
53 877 590 protection piece...................................................................1
for roller bearing 25x52x15 and oil inlet flange, for F3
54 877 560 puller plate ..........................................................................1
for roller bearing 25x52x15, oil seal 30x52x7 and oil inlet cover
55 242 091 hex. nut M10........................................................................1
for roller bearing 25x52x15, oil seal 30x52x7 and oil inlet flange
56 ÷ 59 876 489 puller cap assy., ..................................................................1
for ball bearing 15x32x8, needle baring 22x28x12, oil inlet
flange and oil inlet cover
57 941 730 hex. screw M6x80 DIN 933 .................................................1
58 827 305 washer 6,2/18/2...................................................................1
59 242 211 hex. nut M6 DIN 934 ...........................................................1
60 877 597 protection piece...................................................................1
for needle bearing 22x28x12, vacuum pump and govern.drive
61 877 595 protection piece...................................................................1
for ball bearing 15x32x8, vacuum pump and governor drive
62 874 230 fuel pressure gauge ............................................................1
63-65 877 760 crankcase splitting tool assy.,..............................................1
66 877 570 hand tap drill M18x1............................................................1
to clean the tapping at exchange of coolant bends