S-COM 7K - Assign Control Operator Privilege Level to a Range of Commands

Security
5-5
Assign Control Operator Privilege Level to a
Range of Commands
Changes the Control Operator Privilege on a range of
commands.
• Enter the first and last root number of the command for which a privilege
level change is desired, then enter a 0 or 1 for the privilege level.
• 0 = control command may be used by either the master or the control
operator password.
• 1 = control command may be used only by the master password.
Command Form:
Command Form Data Digit
Assign Control Operator Privilege Level to a
Range of Commands
(PW) 94 (first root
number) (last root
number) x*
0 = used by either
password
1 = used by only
master password
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: All commands may be used by either password.
Example:
Assume that you want to reset all privilege level entries for use by both
passwords, enter the following:
(PW) 94 00 99 0 *
Assume that you want to prevent control operators from changing passwords
or a privilege level enter the following:
(PW) 94 92 94 1 *
Note: If you want to prevent a control operator from accessing a single root
code use the Assign Control Operator Privilege Level command (see page
5-4.)