Scanlab RTC 5 PC Interface Board - Page 607

RTC
®
5 PC Interface Board
Rev. 1.9 e
18 Revision History
607
innovators for industry
Page Name of section / command Change
445
445
446
488
489
set_laser_pulses command
set_laser_pulses_ctrl command
set_laser_timing command
set_standby command
set_standby_list command
Corrected: enhanced allowed range for parameter
HalfPeriod
455 set_mcbsp_out command Added
462 set_n_pixel command Added
555 wait_for_encoder_mode command Added
556 wait_for_mcbsp command Added
584 Jumper 17+18: Setting the Binary
Stack Address
Table corrected: inverted jumper configurations
585 JP10+12: 10 V Output Voltage for
ANALOG OUT1 and ANALOG OUT2
Max. output current specifications added
605 chapter 18 "Revision History" Added