Scanlab RTC 5 PC Interface Board - Page 609

RTC
®
5 PC Interface Board
Rev. 1.9 e
18 Revision History
609
innovators for industry
Page Name of section / command Change
275 get_mcbsp command Corrected: Return value is a signed 32-bit value
276 get_mcbsp_list command Added
276 get_overrun command Added
279 get_standby command Added
280 get_startstop_info command Added: beginning with firmware version 508, the firmware
returns the pulse length error bit (bit #17 or 25), when no
scan system is currently connected.
285 get_text_table_pointer command Corrected: allowed index range
291 get_value command Added: current laser status returns even outside list
execution
296 goto_xy command Added: new comment (external stop signal)
298 home_position command Corrected: A home jump is also executed, if list execution is
stopped via stop_execution or via an external stop signal.
298 home_position_xyz command Added
326 load_auto_laser_control command Changed: return code 11
328 load_correction_file command Added: new error codes
331 load_disk command Added: initialization via
Name = 0
338 load_position_control command Changed: return code 11
340 load_program_file command Added: new error code
346 load_varpolydelay command Changed: return code 11
347 load_z_table command New: Error code 64 as return Value
353 mark_date command
(mark_date_abs command, too)
Added: month and day-of-the-week can also be marked as
normal numerals (parameter Part = 6, 7).
412 set_control_mode command Added: Bit#10 for regular (periodic) external list starts
422 set_ext_start_delay command Added: RTC
®
4 compatibility mode for parameter Delay
423 set_ext_start_delay_list command Changed: Now a normal list command
Added: RTC
®
4 compatibility mode for parameter Delay
426 set_fly_rot command
(analogously for set_fly_rot_pos,
set_fly_x, set_fly_y, set_fly_x_pos
and set_fly_y_pos)
Changed: If unallowed parameter values are supplied, only
deactivates a Processing-on-the-fly correction previously
activated via set_fly_rot but not any other Processing-on-
the-fly correction.
443 set_laser_mode command Added: Laser mode 6
464
465
set_offset_xyz command
set_offset_xyz_list command
Added
493 set_trigger command Added: effective output value via parameter
Signal1/Signal2 = 20-23
499 set_verify command Added: extended download verification
510 simulate_ext_start command Changed: Now a normal list command
Added: RTC
®
4 compatibility mode for parameter Delay
511 simulate_ext_start_ctrl command Added
523 stop_execution command Corrected: A home jump is executed.
527 switch_ioport command Added
528 sync_slaves command Added