Scanlab RTC 5 PC Interface Board - Page 610

RTC
®
5 PC Interface Board
Rev. 1.9 e
18 Revision History
610
innovators for industry
Changes from revision 1.0 to revision 1.1
553 verify_checksum command Added
566 chapter 11 "Demo Programs" Added
567 chapter 12 "Troubleshooting" Added
Page Name of section / command Change
Page Name of section / command Change
30 chapter 2.7 "Notes For RTC
®
4 Users" Extended
60 chapter 5.8 "Upgrading RTC
®
5
Boards"
Added
94 "Ellipse Commands" Added
124 "Inverse Tables" Added
154 chapter 8.1.3 "Position Monitoring" Added
174 "Checking the Z-Axis Calibration" Revised
186 chapter 8.7.5 "Deactivating
Processing-on-the-fly Corrections"
Added
218 "Undelayed and Delayed Short List
Commands (as of Version OUT 515)"
Added
233 arc_abs_3d command Added
235 arc_rel_3d command Added
263 get_error command Added: Bit #10 (DSP version error)
277 get_rtc_version command Added: Bits #16…#23 (DSP version number)
287 get_transform command Added
291 get_value command Added: new comments, code example
293 get_values command Added
312 laser_on_pulses_list command Added
355 mark_ellipse_abs command Added
356 mark_ellipse_rel command Added
409 set_auto_laser_params command Added
409 set_auto_laser_params_list
command
Added
413 set_default_pixel command Added
414 set_default_pixel_list command Added
417 set_ellipse command Added
440 set_laser_control command Added: Bit#5 for laser_on_pulses_list
481 set_sky_writing_para command Added
483 set_sky_writing_para_list
command
Added
524 stop_trigger command Added