RTC
®
5 PC Interface Board
Rev. 1.9 e
18 Revision History
611
Page Name of section / command Change
528 sync_slaves command Changed: Beginning with DLL 518, OUT 517, RBF 514, the
following applies:
• Master/Slave synchronization is only executable via the
sync_slaves command. Synchronization cannot be achieved via
an appropriately sequenced initialization of the boards.
• Synchronization is only applied to downstream slave boards
allocated to the application.
• sync_slaves now automatically executes a simulate_ext_stop
command.
541 -
549
commands timed_para_jump_abs
… timed_para_mark_rel_3d
Eight timed_para commands added
550 transform command Added
552 upload_transform command Added
559 write_io_port_mask command Added
560 write_io_port_mask_list command Added
To Next Page
Loading...
