Section 01 MAINTENANCE
Subsection 02 (STORAGE PROCEDURE)
STORAGE PROCEDURE
SERVICE PRODUCTS
Description Part Number Page
ANTICORROSIO N SP RAY . ............... ............... ............... ............... 219 700 304 ............................................. 9
FUEL STABILIZE R (EUR) .................................... ........................... 779183 ............................................. 7
FUEL STABILIZER .............................................. ........................... 779171 ............................................. 7
LUBRICANT AND ANTI-CORROSIVE (EUR) ......... ... .................. ... 779224 ......................................... 7, 9
LUBRICANT AND ANTI-CORROSIVE............................................ 779168 ......................................... 7, 9
PROCEDURES
PROPULSION SYSTEM
Cleaning and Protecting the
Propulsion System
Clean jet pump by spraying water in its inlet and
outlet and then apply a coating of anti-corrosive
lubricant or equivalent.
SERVICE PRODUCT
Scandinavia
LUBRICANT AND
ANTI-CORROSIVE (EUR)
(P/N 779224)
All other countries
LUBRICANT AND
ANTI-CORROSIVE
(P/N 779168)
Inspecting the J
et Pump
Remove impeller cover and check if jet pump is
water contaminated; if so, refer to
JET PUMP
sub-
section for the repair procedure.
FUEL SYSTEM
Inspecting the
Fuel System
Verify fuel system. Check fuel hoses for leaks.
Replace damaged hoses or clamps if necessary.
Protecting the
Fuel System
Fuel stabilizer should be added in the fuel tank
to prevent fuel deterioration and fuel system
gumming. Follow manufacturer's instructions for
proper use.
SERVICE PRODUCT
Scandinavia
FUEL STABILIZER (EUR)
(P/N 779183)
All other countries
FUEL STABILIZER
(P/N 779171)
NOTICE
Fuel stabilizer should be added
prior to engine lubrication to ensure fuel sys-
tem component protection against varnish
deposits.
Fill up fuel tank completely. Ensure there is no wa-
ter inside fuel tank.
NOTICE
Should any water be trapped inside
fuel tank, severe internal damage will occur to
the fuel injection system.
ENGINE
Replacing the Engine Oil and the Filter
Change engine oil and filter. Refer to
LUBRICA-
TION SYSTEM
subsection.
Flushing the Exhaust System
Flush the exhaust system. Refer to
EXHAUST
SYSTEM
subsection.
Draining the Intercooler
It is important to expel any trapped water that may
have accumulated from condensation in the exter-
nal intercooler.
NOTICE
Failure to drain the intercooler may
cause severe damage to this component.
230 Engines and 300 Engines
1. Remove seats.
2. Remove engine service cover.
3. Ensure there is an alignment line drawn on the
intercooler air inlet hose. This will ensure the
hose is not twisted or kinked on reinstallation.
219100963-004 7
To Next Page
Loading...
Need help?
General
