Section 07 BODY AND HULL
Subsection 02 (HULL)
smr2009-043-036_a
TYPICAL
1. Hydraulic bottle jack
2. Steel plates
13. Heat the edge of the ride plate with a heat gun
to soften the sealant.
14. Start pumping the hydraulic jack slowly.
15. Using a sharp knife, carefully cut the sealant
around the ride plate edges.
16. Pump the hydraulic jack slowly to pry the ride
plate from the hull.
Cleaning the Ride Plate
1. Carefully scrape off all excess sealant from ride
plate a nd hull.
2. Clean hull surface with
BRP HEAVY DUTY
CLEANER (P/N 293 110 001)
to eliminate grease,
dust and sealant residue. Clean fitting threads.
Installing the Ride Plate
1. Reinstall both hose fittings on the ride plate
with new O-rings.
2. Tighten to the specified torque.
TIGHTENING TORQUE
Hose f
ittings
9N•m ± 1N•m
(80 lbf•in ±9lbf•in)
3. Appl
y
LOCTITE 5900 (P/N 293 800 066) sealant as
illu
strated.
219100893-033-004_a
SEALANT APPLICATION
4. Secure ride plate with retaining screws.
NOTE: Measure distance between pivot arms on
ride plate and jet pump support to ensure ride
plate i s centered.
5. Tighten screws to the specified torque and se-
quence.
TIGHTENING TORQUE
Steps 1 to 6
Hand tighten
RIDE PLATE
RETAINING
SCREWS
Steps 7 to
12
27 N•m ± 1 N•m
(20lbf•ft ± 1lbf•ft)
219100893-033-018_b
6. Reins
tall other removed parts. Refer to appro-
priat
e subsections for procedures.
JET P
UMP SUPPORT
Removing the Jet Pump Support
1. Remo
ve the ride plate. Refer to procedure in
this
subsection.
219100893-033 241
To Next Page
Loading...
