SeaDoo GTX Series 2022 User Manual

Section 05 ELECTRICA L SYSTEM
Subsection 02 (WIRING HARNESS AND CONNECTORS)
GENERAL
ACRONYM DESCRIPTION ACRONYM DESCRIPTION
ACC
Accessory
GND3 Engine Ground
BAT+ Battery +
GND4 Battery Ground
BAT- Battery -
HIC Harness Inter Connector to Engine
BRLS
Brake and Reverse Lever
Sensor
HIC1 Harness Inter
Connector to Steering 1
CAPS Camshaft Position Sensor HIC2 Harness Inter Connector to Steering 2
CL Cluster
iBR Intelligent
Braking and Reverse
COM Communication KS Knock Sensor
CPS Crankshaft Position Sensor LTS
Lake temperature sensor
CS Cruise Switch MAPTS Manifold Air Pressure Sensor
CTS Coolant Temperature sensor MSL Multi Switch Left
DCC DC Connection MSR Multi Switch Right
DF Depth finder
OPS Oil Pressure Sensor
DS DESS post OTS Oil temperature sensor
ECMA ECM connector A REG
Voltage Regulator/Rectifier connector
ECMB ECM connector B RSE Right Speaker Enclosure
EGTS Exhaust Gas Temperature SSS Start/Stop Switch
ETC Electronic Throttle Control STS Starter Solenoid
FB Fusebox
STR Starter
FP Fuel Pump
TAS Throttle A ccelerator S e nsor
GND Battery Ground TOPS Tip Over Position Sensor
GND1 Engine Ground USB USB Port
GND2 Engine Ground USB IC USB Inter Connector
PROCEDURES
WARNING
When disassembling any connector for re-
pair or replacement on the vehicle, always
disconnect the battery to ensure all electrical
power is removed and prevent any possi-
bility of a short circuit. Refer to
CHARGING
SYSTEM
subsection.
219100963-012 111

SeaDoo GTX Series 2022 Specifications

General

Engine Type	Rotax 1630 ACE
Engine Displacement	1630 cc
Seating Capacity	3
Hull Material	Fiberglass
Fuel Capacity	70 L
Length	345.1 cm
Width	125.5 cm
Fuel Type	Unleaded gasoline
Hull Type	ST3 Hull