INTRODUCTION
INTRODUCTION
The information and component/system descrip-
tions contained in this manual are correct at time
of writing. BRP however, maintains a policy of
continuous improvement of its products without
imposing upon itself any obligation to install them
on products previously manufactured.
Due to late changes, there may be some differ-
ences between the manufactured product and the
description and/or specifications in this document.
BRP reserves the right at any time to discontinue
or change specifications, designs, f eatures, mod-
els or equipment without incurring obligation.
VEHICLE INFORMATION
HULL IDENTIFICATION NUMBER
(HIN)
The hull identification number is composed of
12 digits:
YDV
12345
L
4
XX
Model year
Year of production
Month o f production
Serial number (a letter may also be used as a digit)
Manufac
turer
It is located on the deck at the rear of watercraft.
219100893-005-001_a
1. Hull Identification Number (HIN)
ENGINE IDENTIFICATION
NUMBER (EIN)
The Engine Identification Number is located on
front end of the engine.
219100893-005-002_a
1. Engine I
dentification Number (EIN)
HOISTIN
G A WATERCRAFT
To work on a watercraft, you should m ount it se-
curely on a stand.
The lifting strap MUST be used to hoist and mount
the watercraft on a stand.
REQUIRED TOOL
LIFTING STRAP (P/N 295
100 758
)
NOTICE
Using any other lifting strap kit than
the one recommended may cause damage to
the vehicle. Bumpers could be torn off.
219100963-002 IX
To Next Page
Loading...
