SeaDoo GTX Series 2022 User Manual

Section 02 ENGINE
Subsection 03 (EXHAUST SYSTEM)
smr2016-012-020_a
SECTION VIEW
1. 57 mm ± 2 mm ( 2 -1/4 in ± 5/64 in)
Center the muffler pre-mark with the BLUE strip
on rubber adapter.
219100893-012-317_a
1. Blue st
rip on rubber adapter
2. Muffler pre mark
A. 30 m m (1.181 in)
Secur
e the rubber adapter to the muffler using re-
taini
ng clamp.
TIGHTENING TORQUE
Rubber adapter
retaining c lamp
9.5 N•m ± 0.5 N•m
(84 lbf•in ±4lbf•in)
Install the exhaust pipe in the rubber adapter. En-
sure rubber adapter is properly seats against ex-
haust pipe shoulder.
smr2008-013-038_a
1. Exhaust pipe shou lder
2. Rubber adapter
Center the rubber adapter strip of the rubber
adapter between both exhaust pipe marks.
Tighten retaining clamps.
TIGHTENING TORQUE
Rubber adapter
retaining clamp
9.5 N•m ± 0.5 N•m
(84 lbf•in ±4lbf•in )
2191008
93-012-312_a
1. Exhaust pipe marks
2. Rubber adapter strip
3. Retain
ing clamps
Install muffler in vehicle. Refer to INSTALLING
THE MUFFLER
in this subsection for complete
procedure.
RESONATOR
Removing the Resonator
Remove the intercooler if equipped. Refer to IN-
TERCOOLER
subsection.
Remove
front exhaust hose.
42 219100893-012

SeaDoo GTX Series 2022 Specifications

General

Engine Type	Rotax 1630 ACE
Engine Displacement	1630 cc
Seating Capacity	3
Hull Material	Fiberglass
Fuel Capacity	70 L
Length	345.1 cm
Width	125.5 cm
Fuel Type	Unleaded gasoline
Hull Type	ST3 Hull