Section 04 FUEL SYSTEM
Subsection 01 (INTELLIGENT THROTTLE CONTROL (iTC))
TARGET SPEED Function
The TARGET SPEED function limits the maximum
towing speed.
Once the R AMP has been selected, an average
PWC target speed for that RAMP will be visible in
the numerical display.
The operator may increase or decrease the tar-
get speed to any value within the selected RAMP
speed range.
Using Ski Mode
Press M ODE button to select the SKI mode.
1. Press OK button when SKI icon flashes.
2. Select ski ramp by using the UP or DOWN ar-
row button. Ramp 1 will give the slowest ac-
celeration.
NOTE: Acceleration ramp will not behave the
same depending on the vehicle type, vehicle
load and water conditions. For safety reasons,
always start using ramp # 1 to familiarize y our
skier with acceleration and then change the ramp
as needed.
3. Press RIGHT arrow button to confirm accelera-
tion ramp.
4. Select the maximum target speed by using the
UP or DOWN arrow button.
5. Press RIGHT arrow button to confirm.
NOTE: At any moment you can use the left and
right arrow to change the ramp and speed selec-
tion.
6. After your selection and when your are ready,
press the OK button to activate the function.
The message SKI READY will display.
Keep throttle fully applied to ski.
Releasing the throttle or applying the brake will
pause the SKI mode, simply press OK button to
reactivate the SKI mode.
Deactivating Ski Mode
To end a ski run and completely deactivate ski
mode, release the throttle to idle, then press the
MODE button.
Learning Key Mode
The learning l key provides a mode of operation
whereby engine power and speed is limited.
There are 5 speed settings available.
By default, the speed setting is no 1.
Contact an authorized Sea-Doo dealer for adjust-
ment.
PROCEDURES
THROTTLE ACCELERATOR
SENSOR (TAS)
General
The throttle accelerator sensor (TAS) is a double
hall effect sensor that sends a signal to the ECM
which is proportional to the throttle lever angle.
219100893-020-001_a
1. Throttle lever
2. Throttle accelerator sen sor (TAS)
First ensure the throttle lever functions ade-
quately. Pull the throttle lever fully in towards the
handlebar, then release it. It must reach the wide
open position and return to the idle position freely
when released. Otherwise, refer to
STEERING
SYSTEM
for an inspection.
Testing TAS Voltage
1. Disconnect the 20-pin steering connector.
219100893-020-004_a
1. 20-
pin connecto r
84
219100963-011
To Next Page
Loading...
Need help?
General
