Section 07 BODY AND HULL
Subsection 01 (BODY)
219100963-021-005
Ensure the mounting tabs are properly located.
219100963-021-003
219100963-021-006
TIGHTENING TORQUE
Support retaining screw
5.5 N
•m ± 0.5 N•m
(49 lbf•in ±4lbf•in)
Mir
ror co v er retaining
screw
3.5
N•m ± 0.5 N•m
(31 lbf•in ±4lbf•in)
SEAT
Cleaning the Seat
For information, refer to
CLEANING AND REPAIR
subsection.
Removing the Seat
To remove the seat, push on the two release but-
tons and lift the back end of the seat.
219001878-022_a
RELEASE BUTTONS
Then pull the latch handle up and remove the seat
from the watercraft.
219001878-032_a
1. Latch handle
Installing the Seat
To install the seat, insert the forward end of the
seat in its retainer.
219100963-021 221
To Next Page
Loading...
