Section 07 BODY AND HULL
Subsection 02 (HULL)
BOW EYELET
Removing the Bow Eyelet
1. Remove the storage bin, refer to
BODY
subsec-
tion.
2. Remove nuts and washers securing the bow
eyelet. Discard nuts.
219100893-033-013_a
TYPICAL – INSIDE HULL
1. Eyelet retaining nuts
3. Remove the bow eyelet from the vehicle.
4. Clean any residue of silicone sealant from the
hull.
Installing the Bow Eyelet
219100893-033-012_a
TYPICAL – BOW EYELET
1. Bow eyelet
2. Small washer
3. Loctite 5150 (silicone sealant) here
4. Rubber washer
5. Large washer
6. Elastic stop nut
REQUIRE
DPRODUCT
LOCATIO
N
CLEAR SILICONE
SEALANT
(P/N 296
000 309)
Inside hull, around holes
TIGHTENING TORQUE
Retaining nuts
14.5 N•m ± 1.5 N•m
(128 lbf•in ±13lbf•in)
STERN EYELETS
Removing the Stern Eyelet
1. Remove seats.
2. Remove engine service cover.
3. Inside hull, unscrew and discard elastic stop
nuts s ecuring the stern eyelet to hull.
4. Pull stern eyelet to remove it from w atercraft.
5. Clean any residue of silicone sealant from the
hull.
Installing the Stern Eyelet
1. Install small washers and nylon washers to
stern eyelet and insert it through the hull.
2. Inside hull, apply
CLEAR SILICONE SEALANT
(P/N 296 000 309)
all around holes.
246 219100893-033
To Next Page
Loading...
