Section 05 ELECTRICA L SYSTEM
Subsection 02 (WIRING HARNESS AND CONNECTORS)
3. Pull back on the terminal wire to ensure the re-
tention fingers are holding the terminal.
4. After all required terminals have been inserted,
the lock must be installed.
F04H6LA
1 1
TYPICAL - CONNECTOR PIN-OUT
1. Terminal position identification numbers
ECM CONNECTOR (MOLEX)
There are 2 connectors on the ECM.
The engin
e wiring harness connector is con-
nected to
ECM connector "A". The vehicle wiring
harness c
onnector is connected to ECM connec-
tor "B".
Each ECM connector has 48 pins however, con-
nectors "A" and "B" are not interchangeable due to
their specific keyways.
smr2009-027-005
ECM CONNECTORS
Removing the Connector
1. To access the ECM, refer to
ELECTRONIC
FUEL INJECTION (EFI)
subsection.
2. Press
and hold the locking tab on the connec-
tor to
be disconnected.
smr2009-045-011_a
LOCKING TAB TO PRESS AND HOLD
3. As you hold the locking tab, rotate the connec-
tor locking cam until it stops.
smr2009-045-012_a
CONNECTOR LOCKING CAM ROTATION TO RELEASE
4. Pull co
nnector off ECM.
smr2009-045-013_a
Installing the Connector
1. Fully open connector locking cam.
219100963-012 113
To Next Page
Loading...
