Section 07 BODY AND HULL
Subsection 02 (HULL)
TIGHTENING TOR
QUE
First step Hand tighten
INLET
GRATE
SCREWS
Second step
27 N•m ± 1 N•m
(20lbf•ft ± 1lbf•ft)
2191008
93-033-002_a
TIGHTENING TORQUE SEQUENCE
4. Reinstall counter nut on front screw inside the
hull.
5. Torque to specification
TIGHTENING TORQUE
Counte
rNut
11 N•m ± 1 N•m
(97 lbf•in ±9lbf•in)Text
RIDE PLATE
Removing the Ride Plate
1. Remove seats.
2. Remove engine service cover.
3. Remove intercooler, refer to
INTERCOOLER
subsection.
4. Remove muffler, refer to
MUFFLER
subsec-
tion.
5. Remove inlet grate, see procedure in this sub-
section.
6. Remove jet pump. Refer to
JET PUMP
subsec-
tion.
7. Drain cooling system. Refer to
COOLING SYS-
TEM
subsection.
8. Disconnect coolant hoses from the ride plate.
9. Remove coolant hose fittings from the ride
plate.
NOTICE
If possible, remove the hose fittings
from the ride plate before removing the ride
plate. If fittings cannot be removed, proceed
with care when removing the ride plate.
10. Heat ride plate retaining screws using a heat
gun.
11. Using an impact tool, remove and discard
retaining screws or reuse with
LOCTITE 271
(RED) (P/N 293 800 005)
.
219100893-033-018_a
PARTS REMOVED FOR CLARITY
1. Ride plate retaining screws
12. Install a low height hydraulic bottle jack and 2
steel plates between ride plate and hull as per
following illustration.
240 219100893-033
To Next Page
Loading...
Need help?
General
