SAFETY NOTICE
SAFETY NOTICE
This manual has been prepared a s a guide to cor-
rectly service and repair GTX, RXT, Fish PRO and
Wake PRO Sea-Doo
®
watercraft.
This edition was primarily published to be used
by technicians who are already familiar with all
service procedures relating to BRP products.
Mechanical technicians should attend training
courses given by BRPTI.
Please note that the instructions will apply only
if proper hand tools and special service tools are
used.
The contents of this manual depicts parts and pro-
cedures applicable to the particular product at the
time of writing. Service and Warranty Bulletins
may be published to update the content of this
manual. Dealer modifications that were carried
out after manufacturing of the product, whether
or not authorized by BRP, are not included.
In addition, the sole purpose of the illustrations
throughout the manual, is to assist identification
of the general configuration of the parts. They are
not to be interpreted as technical drawings or ex-
act replicas of the parts.
The use of BRP parts is most strongly recom-
mended when considering replacement of any
component. Dealer and/or distributor assistance
should be sought in case of doubt.
The engines and the corresponding components
identified in this document should not be utilized
on product(s) other than those mentioned in this
document.
It is understood that certain modifications may
render use of the watercraft illegal under existing
federal, provincial and state regulations.
This manual emphasizes particular information de-
noted by the following wording and symbols:
WARNIN
G
Indicates a potential hazard that, if not
avoided, could result in serious injury or
death.
CAUTION Indicates a hazardous situation
which, if not avoided, could result in minor or
moderate injury.
NOTIC
E
Indicates an instruction which, if not
followed, could result in severe damage to ve-
hicle components or other property.
NOTE: Indicates supplementary information re-
quired to fully complete an instruction.
Although the mere reading of such information
does not eliminate the hazard, your understanding
of the information will promote its correct use.
Always observe common shop safety practice.
Unless otherwise noted, the engine must be
stopped and the tether cord must be removed
prior to perform any services.
Before carrying out any inspection or maintenance
procedure on the watercraft, wait until the engine
and exhaust have cooled down to avoid potential
burns.
Torque wrench tightening specifications must be
strictly adhered to. Use the torque values and ser-
vice products as in the exploded views or in the
procedures when noted.
Locking devices when removed must be replaced
(e.g.: locking tabs, elastic stop nuts, self-locking
fasteners, cotter pins, etc.).
Hoses, cables and locking ties removed during a
procedure must be reinstalled as per factory stan-
dards.
When ordering parts always refer to the specific
model
PARTS CATALOG
.
We strongly recommend that any services be car-
ried out and/or verified by a highly skilled profes-
sional mechanic.
It is understood that this manual may be trans-
lated into another language. In the event of any
discrepancy, the English version shall prevail.
BRP disclaims liability for all damages and/or in-
juries resulting from the improper use of the con-
tents of this publication.
IMPORTANT SAFETY
PRECAUTIONS
We do not provide warnings about many basic
shop safety practices (e.g.: Use Grinding Wheel
– wear safety glasses). If you have not received
shop safety training or do not feel confident about
your knowledge of safe servicing practices, we
recommend that you do not attempt to perform
the procedures described in BRP shop manuals.
You should have a clear understanding of all ba-
sic shop safety practices. You should be wearing
the appropriate clothing, using appropriate safety
219100963-002 VII
To Next Page
Loading...
Need help?
General
