Section 04 FUEL SYSTEM
Subsection 01 (INTELLIGENT THROTTLE CONTROL (iTC))
Once the maximum speed is set, the operator
can vary the watercraft speed from idle speed up
to the set speed using the throttle lever. The set
speed will not be exceeded even if the throttle
lever is fully depressed.
As you proceed under a constant speed setting,
keep your attention level up to maintain good sit-
uational awareness.
Slowing down is a matter of releasing the throttle
lever further than the set point, or by pulling the
iBR lever in.
If the iBR lever is pulled in for braking, Speed Lim-
iter mode is overridden but not deactivated.
Once the iBR lever is released and the throttle is
pulled in to engage forward thrust, the speed lim-
iter function will reengage to limit the watercraft
speed as it was set before.
Prerequisite for Speed Limiter Mode
Activation
NOTE: Speed limiter mode is not available i f slow
speed mode or ski mode (if equipped) is engaged.
Speed limiter MODE can be activated when the
watercraft is going at more then 15m/h.
Activating Speed Limiter Mode
1. Maintain a constant speed.
2. Press the Speed Control button.
219001970-002_b
1. Speed C
ontrol button
You will hear a beep indicating that you are now
in speed limiter mode, and a speed limiter MODE
indicator will be lit.
iVTS
1
219001970-200_d
TYPICAL
1. Speed limiter/Slow Speed M O DE INDICATOR
NOTE: Activating speed limiter mode of operation
only limits the maximum speed available when de-
pressing the throttle l ever. The throttle lever must
be held in to maintain forward speed. Watercraft
speed can be varied from idle up to t he set c ruise
speed using the throttle lever once the speed lim-
iter function is activated. Watercraft speed may
vary depending on water conditions during use.
To change the s et speed; keep throttle lever fully
depressed and press the UP or DOWN arrow but-
ton.
Deactivating Speed Limiter Mode
To deactivate speed limiter mode:
1. Release the throttle lever.
2. Press the speed limiter button.
Deactivation of speed limiter mode is indicated by:
– The speed limiter indicator will go off.
NOTE: If the throttle lever is not fully released
when the button is pressed to deactivate the
speed limiter mode, the speed limiter MODE in-
dicator will remain on. The speed limiting function
will stay active until the throttle is fully released,
then the speed limiter MODE indicator will go
out.
Slow Speed Mode
The Intelligent Throttle Control also allows for a
Slow Speed Mode where the driver can adjust and
set idle speed. This is usefull when operating in
slow speed zones where the driver must be es-
pecially attentive to possible obstacle avoidance.
The operator can set idle speed between
1.6km/hto11km/h(1MPHto7MPH).
If you a ccelerate above a pproximately 14 km/h
(9 MPH) , Slow Speed Mode will be deactivated
and the engine will return to idle RPM when the
throttle i s released.
Should a situation arise where the operator must
stop or accelerate quickly away from a hazardous
situation, pulling in the iBR lever, or pulling in on
82 219100963-011
To Next Page
Loading...
Need help?
General
