Section 06 ST EE RING AND PROPULSION
Subsection 01 (STEERING)
2. Remove the screw and washer securing throt-
tle lever.
3. Remove throttle lever.
219100893-028-012_a
1. Retainin
gscrew
2. Washer
3. Throttle lever
4. Clean th
rottle lever area from dust or any de-
posits.
5. Apply grease on pivot and the outer surface of
the return tab.
SERVICE PRODUCT
Scandinavia
SYNTHETIC GREASE
(EUR) (P/N 779231)
All other countries
SYNTHETIC GREASE
(P/N 779162)
219100963-017-001
1. Appl
y grease here
6. Install the lever.
6.1 Ins
tall lever on pivot.
6.2 Insert sensor lever end into throttle lever
fork.
6.3 Position the return tab against the handle-
bar.
6.4 Secure the lever with washer and screw.
TIGHTENING T
ORQUE
Lever screw
1N•m ± 0.2N•m
(9 lbf•in ±2l
bf•in)
7. Reinstall all removed parts using appropriate
procedures.
STEERING CABLE
Replacing the Steering Cable
Remove the seat and top cover.
Remove the
gauge support. Refer to
INFORMA-
TION CENTE
R
subsection.
219100893-028-014_a
1. Detach steering cable from steering column.
1.1 Remove the steering cable support
screws.
219100963-017 157
To Next Page
Loading...
