Section 03 ELECTRONIC MANAGEMENT SYSTEMS
Subsection 02 (iCONTROL SYSTEM)
iCONTROL SYSTEM
GENERAL
The iControl (intelligent Control) system may con-
sist of the following systems:
– Intelligent Throttle Control (iTC)
– Intelligent Brake and Reverse (iBR).
The information center (gauge) and handlebar
switches are used to navigate through and select
several functions, modes of operation and change
certain settings and system parameters using the
appropriate handlebar controls.
Each control is electronic and provides a com-
mand signal to an electronic module whose
function is to assure proper operation of its sys-
tem within set parameters.
For a comprehensive and complete description
of the information center, refer to
INFORMATION
CENTER
subsection.
iTC (INTELLIGENT THROTTLE
CONTROL)
The iTC is an electronic throttle control system
(ETC) that includes a cable-less throttle control
(TAS) located on the RH side of handlebar and
an electric throttle actuator (ETA) located on the
throttle body.
The iTC allows functions such as touring mode,
sport mode, eco mode, cruise control, slow speed
mode and ski mode as well as a more precise con-
trol of the engine power.
For a comprehensive and complete description
of this system, refer to
INTELLIGENT THROTTLE
CONTROL (ITC)
subsection.
iBR (INTELLIGENT BRAKE AND
REVERSE)
The iBR is a brake and reverse system used to
avoid obstacles, gradually slow down or stop
the watercraft, or drive backwards by lowering
the iBR gate that redirects the water flow at the
outlet of the jet pump nozzle.
For a comprehensive and complete description of
this system, refer to
IBR, REVERSE AND VTS
sub-
section.
219100893-016 67
To Next Page
Loading...
Need help?
General
