Section 07 BODY AND HULL
Subsection 01 (BODY)
Position a b all on e ach ends of spring.
Install a feeler gauge over each balls.
Tighten the locking tie in order to retain feeler
gauges and balls.
smr2008-035-018_a
1. Feeler gaug
es
2. Ball
Apply grease in both recesses of the extension
tube.
SERVICE PRODUCT
Scandinavia
SYNTHETIC GREASE
(EUR) (P/N 779231)
All other countries
SYNTHETIC GREASE
(P/N 779162)
smr2008-035-019_a
1. Extension tube
2. Recesses
Slide the handle stem into the extension tube.
Remove feeler gauges and locking tie.
Locking Strap
Install lock and insert the end of the locking strap
over the retaining pin.
smr2008-035-021_a
1. Retaining pin
2. Locking strap
Using a suitable tool, position the locking strap in
its groove.
smr2008
-035-022_a
1. Locking strap
2. Locking strap groove
Reinsta
ll the wake pylon trim.
Do not install the handle into wake pylon yet.
Install
ing the Wake Pylon
The installation is the reverse of the removal pro-
cedure.
REAR EXTENSION (FISH PRO)
The following procedures are intended to replace
an existing extension and not to install an exten-
sion on a regular GTX.
WARNING
Do not install an extension on any other PWC
than a Fish PRO model.
Removing the rear Extension
Remove carpet, refer to
CLEANING AND REPAIR
subsection.
234 219100963-021
To Next Page
Loading...
