Siemens SIMATIC ET 200S - Page 100

Configuration Options
3-36
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Prerequisites
For option handling you require:
• IM 151-1 STANDARD (from 6ES7 151-1AA03-0AB0) or IM 151-1 FO
STANDARD interface module (from 6ES7 151-1AB02-0AB0)
• for configuring the GSD file as per the table below
DPV0 operation DPV0/DPV1 operation
SI02806A.GSx SI02806B.GSx SI03806A.GSx SI03806B.GSx
from 07/2003 (from V1.0)
6ES7 151-1AA03-0AB0 X -- -- --
6ES7 151-1AB02-0AB0 -- X -- --
6ES7 151-1AA04-0AB0 X -- X --
6ES7 151-1AB03-0AB0 -- X -- X
Note
You do not require a GSD file for option handling in STEP 7:
• as of STEP 7 V5.2 Service Pack 1 and
• the current HW update for the interface and power modules. Integrate the HW
update in HWCONFIG using the Option s > I nstall HW Updates manu
command. You can download the HW updates from Customer Support on the
Internet.
You can find the description of option handling in the STEP 7 help system.
•
At least one PM E 24-48 VDC or PM E 24-48 VDC/24-230 VAC power module
must be present in the configuration.
• RESER VE modules as replacements for future electronic modules
Note
If the actual configuration of an ET 200S station does not match the configured
preset, a diagnosis is reported if the check for the slots is not enabled.