Siemens SIMATIC ET 200S - Terminal Assignment of the 2 DO 24 VDC;0.5 a Standard

Digital Electronic Modules
11-48
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Special feature
When the rated load voltage of 24 VDC is connected at the power module via a
mechanica contact, the digital outputs carry a ”1” signal for approx. 50 µs because
of the circuit type. This must be considered when the module is connected to fast
counters.
Connection assignment
The following table shows the terminal assignment of the 2DO 24 VDC/0.5 A
Standard for the various terminal modules:
Table 11-19 Terminal assignment of the 2DO 24 VDC/0.5 A Standard
View
Terminal assignment Remarks
MM
VDCVDC
AUX1 (e.g. PE)
DO
1
DO
0
AUX1 (e.g. PE)
2-wire 3-wire 4-wire
TM-E15S24-
A
1 and 2DO 24
V
DC/o.5
A
Standard
CH1CH0
2
3
4
6
7
8
1
5
AUX1 must be occupied
with 4 wires at PE.
AA
Channel 0:
Terminals 1 to A4
Channel 1:
Terminals 5 to A8
DO: Output signal
(max. 0.5 A per channel)
24 VDC: Sensor supply
M : Load power supply
ground
MM
VDCVDC
DO
1
DO
0
2-wire 3-wire
TM-E15S24-01 and 2DO 24 VDC/0.5 A Standard
CH1CH0
2
3
4
6
7
8
1
5
n. c.n. c.
Channel 0: Terminals 1 to 4
Channel 1: Terminals 5 to 8
DO: Output signal
(max. 0.5 A per channel)
24 VDC: Sensor supply
M : Load power supply
ground
Terminals 4 and 8 can be
used for connection of
cables that are not required
uto30VDC.