Siemens SIMATIC ET 200S - Wiring the IM151-3 PN interface module

Wiring and Fitting
5-19
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
5.4.6 Wiring the IM151-3 PN interface module
Features
Connect the supply voltage and bus connection plug to the IM151-3 interface
module.
Prerequisites
• Wire the interface module with the supply voltage switched off.
• Adhere to the wiring rules (see Section 5.4).
Tool required
• 3 mm screwdriver
• Industrial Ethernet Fast Connect Stripping Tool (6GK1 901-1GA00)
(stripping tool for Industrial Ethernet Fast Connect installation lines)
Required accessories
• PROFINET connector conforming to the specifications in the
PROFINET Installation Guide
• Industrial Ethernet Fast Connect installation lines
The following are suitable:
-- Fast Connect Standard Cable 6XV1 840-2AH10
-- Fast Connect Trailing Cable 6XV1 840-3AH10
-- Fast Connect Marine Cable 6XV1 840-4AH10
Installing bus terminal connector
Install the PROFINET connector in accordance with the directions in the
PROFINET Installation Guide.