Siemens SIMATIC ET 200S - Example of the Use of the RESERVE Modules

Configuration Options
3-37
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Example of the use of the RESERVE module s
Option 1 Option 2
Basic
config.
IM 151-1 STANDARD
PM-E 24-48 VDC
2DI 24 VDC
2DO
2DI 24 VDC
2DO 2DO 2DO
PM E-24 VDC
4DI 4DI
Bus termination
4DI
2DO 2DO 2DO 2DO
2AI U
PM E-24 VDC
PM-E 24-48 VDC
2DI 24 VDC
RESERVE
2DI 24 VDC
RESERVE RESERVE RESERVE
PM E-24 VDC
4DI 4DI 4DI
RESERVE RESERVE RESERVE RESERVE
2AI U
IM 151-1 STANDARD
PM E-24 VDC
Bus termination
Basic config.
Sensors/actuators
This setup
must be
configured
(HWCONFIG,
COM
PROFIBUS)
Future
planned
maximum
configuration
of the ET
200S
PM-E 24-48 VDC
2DI 24 VDC
RESERVE
2DI 24 VDC
RESERVE RESERVE RESERVE
PM E-24 VDC
4DI 4DI 4DI
2AI U
PM E-24 VDC
Sensors/actuators
IM 151-1 ST ANDARD
Bus termination
1st version:
Preparation
using
RESERVE
modules and
prewiring
2nd version:
Preparation
using
RESERVE
modules and
prewiring. The
RESERVE
modules at the
right-hand end
of the s tation
are not present.
You must install
and wire this
configuration
OR
OR
You must install
and wire this
configuration
Figure 3-10 Example of the use of the RESERVE modules