4-1
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Installation
Important information
!
Warning
Open operating equipment
The modules of an ET 200S are open operating equipment. This means that you
can only install the ET 200S in cases, cabinets or electrical plant rooms where
they will only be accessible with a key or a tool. Only trained or authorized
personnel should have access to the cases, cabinets or electrical plant rooms.
Simple installation
The ET 200S distributed I/O system is designed for simple installation.
Chapter overview
Chapter Description Page
4.1 Installation rules, installation position, rail, installation measurements
and clearances
4-2
4.2 Installing the interface module 4-4
4.3 Installing the TM-P and TM-E terminal modules 4-6
4.4 Replacing the terminal box on the terminal module 4-8
4.5 Installing the terminating module 4-10
4.6 Installing the shield contact 4-11
4.7 Applying slot number labels and color identification
labels
4-13
4.8 Setting the PROFIBUS Address 4-15
4
To Next Page
Loading...
