Siemens SIMATIC ET 200S - Table of Contents

ix
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Contents
1 Product Overview 1-1...................................................
1.1 What are distributed I/O systems? 1-1..............................
1.2 What is PROFINET IO? 1-4.......................................
1.3 What is the ET 200S distributed I/O system? 1-5.....................
1.4 Guide to the ET 200S manuals 1-12.................................
2 Brief Instructions on Commissioning ET 200S 2-1.........................
2.1 Commissioning on PROFIBUS DP 2-1..............................
2.2 Commissioning on the PROFINET IO 2-10...........................
3 Configuration Options 3-1...............................................
3.1 Finely-graduated modular system 3-2..............................
3.2 Power supply of the ET 200S 3-4..................................
3.3 Placement and connection to common potential of power modules 3-5..
3.4 Configuration options of the interface modules 3-7...................
3.5 Configuration options between the terminal modules
and electronic modules 3-10........................................
3.6 Direct data exchange on the PROFIBUS DP 3-27.....................
3.7 Clocking on PROFIBUS DP 3-28...................................
3.8 Option handling on PROFIBUS DP 3-34.............................
3.9 Identification data 3-42............................................
3.10 Limitations on the number of modules that
can be connected/maximum configuration 3-45.......................
4 Installation 4-1..........................................................
4.1 Installation rules, installation position, rail, installation measurements
and clearances 4-2...............................................
4.2 Installing the interface module 4-4..................................
4.3 Installing the TM-P and TM-E terminal modules 4-6..................
4.4 Replacing the terminal box on the terminal module 4-8................
4.5 Installing the terminating module 4-10...............................
4.6 Installing the shield contact 4-11....................................
4.7 Applying slot number labels and color identification labels 4-13..........
4.8 Setting the PROFIBUS address 4-15................................