Siemens SIMATIC ET 200S - Commissioning and startup of the ET 200 S on PROFINET IO

Commissioning and Diagnostics
6-57
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
6.2 Commissioning and diagnostics on PROFINET IO
Chapter overview
Chapter Description Page
6.2.1 Configuring the ET 200S on PROFINET IO 6-57
6.2.2 Commissioning and startup of the ET 200S on PROFINET IO 6-59
6.2.3 Diagnostics with LED display 6-61
6.2.4 Diagnostic messages of the electronic modules 6-64
6.2.5 Evaluating the interrupts of the ET 200S 6-65
6.2.6 Diagnostics with STEP 7 6-66
6.2.1 Conf iguring the ET 200S on PROFINET IO
Introduction
The IM151-3 PN interface module must have the device name assigned (see
Section 5.6).
Configuration is the configuration and parameter setting of the ET 200S.
• Configuring: The systematic arrangement of the different ET 200S modules
(setup)
• Configuration: setting the ET 200S parameters using the configuration software
Note
The ET 200S is included in the hardware catalog of HWCONFIG:
• IM151-3 PN: as of STEP 7 V5.3 and Service Pack 1
The STEP 7 online help provides more detailed information on how to proceed.