Siemens SIMATIC ET 200S - Parameters for the IM151-1 STANDARD and IM151-1 FO STANDARD Interface Modules

Interface Modules
8-2
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Parameters for the IM151-1 STANDARD and IM151-1 FO STANDARD interface
modules
Table 8-2 Parameters for the IM151-1 STANDARD and IM151-1 FO STANDARD interface
modules
IM151-1 STANDARD/IM151-1
FO STANDARD
Value range Default
4)
Applicability
DP interrupt mode DPV0/DPV1 DPV0 ET 200S
Bus length ≤ 1m/>1m ≤1m ET 200S
Operation with Set and <>
Actual Configuration
1)
Disable/enable Disable ET 200S
Diagnostic interrupt
3)
Disable/enable disable ET 200S
Process interrupt
3)
Disable/enable disable ET 200S
Insert/Remove module
interrupt
2) 3)
Disable/enable disable ET 200S
Module diagnosis Disable/enable enabled ET 200S
Module status Disable/enable enabled ET 200S
Channel-specific diagnostics Disable/enable enabled ET 200S
Option handling, general Disable/enable disable ET 200S
Option handling: Slots 2 to 63 Disable/enable disable Module
Analog-value format SIMATIC S7/
SIMATIC S5
S7 ET 200S
Interference Frequency
Suppression
50 Hz/60 Hz 50 Hz ET 200S
Reference junction slot None/2 to 63 none ET 200S
Reference junction input RTD on channel 0/
RTD on channel 1
0 ET 200S
1)
Note also the option handling parameters (see Chapter 3.8).
2)
In the device database file, the default setting of the parameter is ”Disable”.
3)
Only configurable in DPV1 mode.
4)
The default settings are applicable for the defaultstartup (if no otherparameters are specified
by the DP master).