Siemens SIMATIC ET 200S - Page 247

Interface Modules
8-3
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Parameters for the IM151-1 HIGH FEATURE interface module
Table 8-3 Parameters for the IM151-1 HIGH FEATURE interface module
(parameter assignment tab)
IM151-1 HIGH FEATURE
Value range Default
3)
Effective range
DP interrupt mode DPV0/DPV1 DPV1 ET 200S
Operation at Preset -- <>
Actual configuration
Disable/enable enabled ET 200S
Diagnostics interrupt
2)
Disable/enable enabled ET 200S
Hardware interrupt
2)
Disable/enable enabled ET 200S
Insert/Remove module
interrupt
1) 2)
Disable/enable enabled ET 200S
Module diagnosis Disable/enable enabled ET 200S
Module status Disable/enable enabled ET 200S
Channel-specific diagnostics Disable/enable enabled ET 200S
Analog-value format SIMATIC S7/
SIMATIC S5
S7 ET 200S
Interference Frequency
Suppression
50 Hz/60 Hz 50 Hz ET 200S
Reference junction slot None/2 to 63 none ET 200S
Reference junction input RTD on channel 0/
RTD on channel 1
0 ET 200S
1)
In the device database file, the default setting of the parameter is ”Disable”.
2)
Only configurable in DPV1 mode.
3)
The default settings are applicable for the default startup (if no other parameters are
specified by the DP master).
Table 8-4 Parameters for the IM151-1 HIGH FEATURE interface module (clocking tab)
IM151-1 HIGH
FEATURE
Value range Default setting Effective range
Synchronize DP slave
with DP cycle
1)
Disable/enable disable ET 200S
Time Ti (read in
process values)
1)
(Values are preset by
STEP 7)
(Value is preset by
STEP 7)
ET 200S
Time To (output
process values)
1)
(Values are preset by
STEP 7)
(Value is preset by
STEP 7)
ET 200S
1)
Only parameterizable as of STEP 7 V5.1 with ServicePack 3