EasyManua.ls Logo

Siemens SIMATIC ET 200S - Page 352

Siemens SIMATIC ET 200S
652 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Digital Electronic Modules
11-32
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Technical data
Dimensions and weight
Dimensions W x H x D 15 x 81 x 52 (mm)
Weight Approx. 35 g
Module-specific data
Supports clock
synchronized mode
Yes
Number of inputs 4
Cable length
Unshielded max. 600 m (164 ft)
shielded max. 1,000 m
(164 ft)
Voltages, currents, electrical potentials
Rated supply voltage (from
power module)
24/--48 VAC/VDC
horizontal installation
up to 60 °C
vertical installation
up to 40 °C
Polarity reversal
protection
Ac or DC
automatically
Electrical isolation
Between the channels No
Between channels and
backplane bus
Yes
Permitted potential
difference
Between different
circuits
75 VDC, 60 VAC
Insolation tested with 2500 V DC
Current consumption
from power
supply L+
Dependent on the
sensor
From the backplane bus max. 10 mA
Power loss of the module Typical 0.7 W
Status, interrupts, diagnostics
Status display green LEDs per
channel
Diagnostic functions
Group error display
Configurable
red LEDs (SF)
Sensor Power Supply Outputs
Output voltage
Loaded Min. L+ (--0.5 V)
Output current
Rated v alue 500 mA
Permitted range
Short-circuit protection
0to500mA
Yes, by module
Data for selecting a sensor
Input voltage
Rated v alue 24 to 48 VUC
for ”1” signal -- 1 5 V D C
up to --57.6 VDC
15 V DC
up to 57.6 V DC
15 V AC
up to 48 V AC
for ”0” signal -- 6 V D C
upto6VDC
0VACupto5VAC
Frequency range 47 Hz to 63 Hz
Input current
For signal ”1”
from 4 mA to
10 mA
Input delay
”0” to ”1” transition
”1” to ”0” transition
Max. 15 ms
Max. 15 ms
Input characteristic
1)
Connection of 2wire
BEROs
possible
permitted quiescent
current
max.0.5upto2
mA
2)
Sensor circuit
Resistor circuit of sensor to
wire-break monitor
Rated voltage
24 V (15 V to 35 V)
Rated voltage
48 V (30 V to 60 V)
18 k
39 k
1)
IEC 61131 does not provide specification for UC
modules. However, the values comply with
IEC 61131 to the extent possible.
2)
A minimum load current is required with
wire-break monitoring.

Table of Contents

Other manuals for Siemens SIMATIC ET 200S

Related product manuals