Siemens SIMATIC ET 200S - Page 439

Analog Electronic Modules
12-33
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Table 12-33 Parameters RTD, TC analog electronic modules
2AI RTD
Standard
Effective
range
Default
setting
Value range2AI TC High
Feature
2AI TC
Standard
-- -- -- Measurement
type/range
-- -- -- • disabled
• Voltage ¦ 80 mV
• TC-ELTypeT(Cu-CuNi)
• TC-EL Type K (NiCr-Ni)
• TC-ELTypeB
(PtRh-PtRh)
• TC-ELTypeN
(NiCrSi-NiSi)
• TC-ELTypeE
(NiCr-CuNi)
• TC-ELTypeR(PtRh-Pt)
• TC-ELTypeS(PtRh-Pt)
• TC-ELTypeJ
(Fe-Cu-Ni)
• TC-ELTypeL
(Fe-Cu-Ni)
TC-EL
Type K
(NiCr-Ni)
Channel
Measurement
type /range
• disabled
• Voltage ¦ 80 mV
• TC-ELTypeT(Cu-CuNi)
• TC-EL Type K (NiCr-Ni)
• TC-ELTypeB
(PtRh-PtRh)
• TC-ELTypeC
(WRe-WRe)
• TC-ELTypeN
(NiCrSi-NiSi)
• TC-ELTypeE
(NiCr-CuNi)
• TC-ELTypeR(PtRh-Pt)
• TC-ELTypeS(PtRh-Pt)
• TC-ELTypeJ
(Fe-Cu-Ni)
• TC-ELTypeL
(Fe-Cu-Ni)
TC-EL
Type K
(NiCr-Ni)
Channel
1)
With thermocouples only. A configuration error occurs when wire-break diagnostics and voltage
measuring range are enabled. The module does not start.
2)
Wire break is only detected with the constant current cables.