EasyManua.ls Logo

Siemens SIMATIC ET 200S - Page 499

Siemens SIMATIC ET 200S
652 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Analog Electronic Modules
12-93
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Analog Value Formation
Measurement principle integrating
Integration / conversion
time / resolution per
channel:
Integration time
selectable
Yes
Interference frequency
suppression in Hz
60 50
Integrationtimeinms 16.7 20
Basic conversion time
incl. integration time in
ms
55 65
Additional conversion
time for wire break
diagnostics in ms
20 20
Cycletimeinms Number of active
channels per
module x conversion
time
Resolution (incl.
overshoot range)
15 bits + sign
Interference Suppression, Error Limits
Interference voltage sup-
pression for f= n x (f11%),
(f1 = interference
frequency)
Common mode
interference (U
SS
)
Common mode
interference
(peak value of
interference < rated
value of the input range)
min. 90 dB
min. 70 dB
Crosstalk between inputs min. --50 dB
Operational error limits
(across complete tempera-
ture range, in relation to in-
put range)
1
0.6 %
Basic error limit (operational
error limit at 25 _C, related
to the input range)
1)
0.4 %
Temperature error (in rela-
tion to input range)
0.005 %/K
Linearity error (relative to
the input range)
0.01 %
Repetition accuracy
(in transient state at 25_C,
relative to input range)
0.05 %
Data for selection of the sensor
Input range (rated
value)/input resistance
Voltage 80 mV/min. 1 M
Thermocouple Type E, N, J, K, L, S,
R, B, T/min. 1 M
Permitted continuous input
voltage (destruction limit)
10 V, continuous
Connection of signal
generators
For voltage
measurement
possible
Characteristics linearization Yes, configurable for
Type E, N, J, K, L, S,
R, B, T as per
IEC 584
Temperature compensation
Internal temperature
compensation
Not possible
External temperature
compensation by
looping a compensation
unit into the measuring
circuit
Possible, one
external
compensation
unit per channel
External compensation
by means of
temperature value
acquired at an analog
module of the same
ET 200S station
Yes
Smoothing of measured
values
Yes, configurable in
4 stages by digital
filtering
Level
No
weak
medium
strong
Time constant
1 x cycle time
4 x cycle time
32 x cycle time
64 x cycle time
1)
with Type N: from --150 _C, Type B:
from 200 _C,
Type T: from --230 _C

Table of Contents

Other manuals for Siemens SIMATIC ET 200S

Related product manuals