Siemens Sinumerik 840DiE sl - Page 102

01/2007
3.3 Overview of connections
3-102
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
1) Connector:
6ES7972–0BA41–0XA0; cable outlet 35
0
, without socket connector for
programming device
6ES7972–0BB41–0XA0; cable outlet 35
0
, with socket connector for pro-
gramming device
6ES7972–0BA12–0XA0; cable outlet 90
0
, without socket connector for
programming device
6ES7972–0BB12–0XA0; cable outlet 90
0
, with socket connector for pro-
gramming device
Cable:
6XV1830–0EH10; by the meter, not trailable
6XV1830–3EH10; by the meter, trailable
2) Connector:
6GK1500–0EA02; cable outlet 180
0
, without PG socket connector for pro-
gramming device
Cable:
6XV1830–0EH10; by the meter, not trailable
6XV1830–3EH10; by the meter, trailable
3) Connector:
6ES7972–0BB41–0XA0; cable outlet 35
0
, with socket connector for pro-
gramming device
6ES7972–0BB12–0XA0; cable outlet 90
0
, with socket connector for pro-
gramming device
Cable:
6XV1830–0EH10; by the meter, not trailable
6XV1830–3EH10; by the meter, trailable
4) The cable is included in the scope of supply.
5) For an overview of the standard PC interfaces, see Fig. 3-8, Page 3-100
and Fig. 3-9, Page 3-100, as well as:
References: /BH/ Operator Components Manual
Component PCU 50.3
6) Cable: 6FX8002–2CP00–1Aj0
7) For a detailed overview of the connection to the AD14 please refer to
References: /ADI4/ Analog drive interface for four axes
Connection overview
8) Connection via Fast Connect (insulation displacement method) see:
References: SIMATIC Manual: Diagnostic repeater for PROFIBUS DP
9) Can be assigned parameters either as an MPI or a PROFIBUS interface.
Only the PLC has access to this PROFIBUS interface. No drives and no
NCK I/Os can be operated via this PROFIBUS line.
Note
The length codes for preassembled cables 6FXj002–... can be found in:
References: Catalog NC 61, MOTION–CONNECT.
3 Design