Siemens Sinumerik 840DiE sl - Drives of Control Unit 2: Additional BICO Interconnection

01/2007
9.3 Example for systems with more than 6 drives
9-265
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
The project should be created according to the description from Section 9.2,
Page 9-243. Both drive units must be displayed in the preview window.
Preview
STARTER Project Wizard
Refresh
view
Introduction
1.
Create a
new project
2.
Set PG/PC
interface
3.
Insert
drive
device
4.
Summary
Project
Drive_Unit_Addr10
Drive_Unit_Addr20
Fig. 9-2 STARTER: Project Wizard (excerpt)
The automatic acquisition of the component topology and configuration is per-
formed for each drive unit according to Section 9.2.2, Page 9-247.
The commissioning of the drive components must be performed in accordance
with the sections listed above: 9.2.3, Page 9-250 to Section 9.2.15, Page 9-262.
Parameter ”p864, BI: Infeed operation” of all drives must be interconnected to
the corresponding signal of the infeed ”r863: Bit0, Infeed operation”.
S Control_Unit_1
Drives controlled by Control_Unit_1 (Drive_1..._5) are interconnected auto-
matically.
S Control_Unit_2
Drives controlled by Control_Unit_2 (Drive_6..._9) must be manually inter-
connected (see the following section).
9.3.2 Drives of Control Unit 2: Additional BICO interconnection
The infeed can be connected with a Control Unit via DRIVE CliQ. Since Con-
trol_Unit_1 is connected with the infeed, it is not possible to make a BICO inter-
connection from drive parameter ”p864, BI: Infeed operation” to the infeed sig-
nal ”r863: Bit0, Infeed operation” for the drives controlled by Control_Unit_2
(Drive_6..._9).
S Drive: p864, BI: Infeed operation
S Infeed: r863: Bit0, Infeed operation
Creating a project
Component
topology
Commissioning
Infeed:
Operation
9 Drive Commissionin
g
(
SINAMICS
)