Siemens Sinumerik 840DiE sl - Performing the Measurement

01/2007
14.6 Trace function
14-447
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
– Individual bits: xxxx xxxx
– 1: selected
– 0: not selected.
By default, all bits are selected.
The input field Threshold is only used to enter the triggering threshold for the
physical address of trace 1. If you exit the input screen form with the Ok soft-
key, this hex value is then entered in the field Threshold of the main screen of
the trace function.
14.6.4 Performing the measurement
After parameterization has been completed, you then enable measurement by
pressing softkey Start.
The measurement is carried out once the set trigger condition of trace 1 is ful-
filled.
The measurement is completed after the set measurement duration is expired.
The graphics are generated automatically when the measurements are finished.
Use the Display softkey to call the display functions of the graphics (see next
Section).
With the Stop softkey, you can cancel a running measurement at any time.
A canceled measurement cannot be displayed.
Input field:
Threshold
Softkey:
Start
Terminating the
measurement
Softkey:
Stop
14 Drive O
p
timization with HMI Advanced