15-459
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
User Data Backup/Standard Commission-
ing
15.1 Explanations on data backup
User data refers to all data or data fields that can be entered by the user to
achieve the specific functionality of the SINUMERIK 840Di sl and the connected
drives.
In the case of a data backup, e.g. after commissioning of the control system, the
user data selected through the user interface are written to a so–called series
startup file.
After a series startup file has been read in, the control system is in its original
status again as it was at the time of data backup.
The past has shown that the following times are recommended to carry out data
backups:
– After commissioning
– After changing machine–specific settings
– After service, e.g., after replacement of a hardware component, software
upgrade, etc.
– Before activation of memory–configuring machine data. A warning
prompting you to back up is displayed automatically.
You can save user data using one of the following applications:
S SINUMERIK user interfaces: HMI Advanced (option).
S Commissioning tool: SinuCom NC
You can save user data for the following components either individually or together.
– NCK
– PLC
– HMI
– SIMODRIVE PROFIBUS drives
Currently, the user data (projects) for SINAMICS S120 drive units must be
saved separately with the STARTER commissioning tool.
For detailed information on data backup, please refer to:
References: SinuCom NC:
Online Help
HMI Advanced:
/BAI/ Operator’s Guide HMI Advanced
User data
Times for
data backup
Data backup of
various
components
SINAMICS S120
15
To Next Page
Loading...
