01/2007
17.3 Assigning via Automation License Manager
17-490
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
Note
If the view is not automatically refreshed, you can refresh the view manually.
See Section 17.3.5, Page 17-493.
17.3.4 Assigning parameters to the TCP/IP communication with a
control system
To be able to read or transfer license information to or from the MCI board of a
control system, the Automation License Manager must communicate with the
control system via TCP/IP.
Requirements
S HMI basic software is installed
S SINUMERIK–specific plug–ins are enabled
Note
If the SINUMERIK user interface ”HMI Advanced” is installed on the same
computer (PC/PG) as the Automation License Manager you can set the IP
address using the user interface.
The IP address for the control system with which both HMI Advanced as well
as the Automation License Manager communicate is set via the following
dialog:
Operating area switchover > Installation > HMI > NCU connection
This requires at least the password of protection level 2 (manufacturer) to be
set.
General communication parameters
The default general communication parameters for the HMI basic software are
stored in the following initialization file:
<Installation drive>:\Siemens\Sinumerik\HMI–Advanced\mmc2\MMC.INI
User–specific communication parameters
The user–specific communication parameters for the HMI basic software are
stored in the following initialization file:
<Installation drive>:\Siemens\Sinumerik\HMI–Advanced\user\MMC.INI
During evaluation of the initialization data when booting the HMI basic software,
user–specific communication parameters have priority over general commu-
nication parameters.
Background
17 License Mana
ement
To Next Page
Loading...
