Siemens Sinumerik 840DiE sl - Infeed: Error Acknowledgement(BICO Interconnection)

01/2007
9.2 ONLINE commissioning
9-259
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
9.2.11 Infeed: Error acknowledgement(BICO interconnection)
To acknowledge an error for the infeed, use the ”PROFIBUS PDA1 received”
signal from the first drive.
S Infeed: p2103[0] BI: 1. Acknowledge faults
S Drive: Drive_1, r2090: Bit7, BO: PROFIBUS PZD1 receive bit–serial
Perform the following actions:
1. Double–click Project > Drive_Unit_Addr10 > Infeeds > Infeed > Control
Logic to open control logic configuration in the project navigator.
2. Click the binector input symbol of signal ”p2103[0] BI: 1. Acknowledge
faults” and from the list select Drive_1 > Further interconnections > r2090:
Bit7, BO: PROFIBUS PZD1 receive bit–serial
Drive_01, r2090: Bit7, BO: PROFIB
p840[0] BI: ON/OFF1
Control Logic
Control word sequential control infeed
Optimize view
p844[0] BI: 2. OFF2
p845[0] BI: 2. OFF2
r2103[0] BI: 1. Acknowledge faults
1
Control word, faults/alarms
Infeed
1
0
HelpClose
p2103 BI: 1. Acknowledge faults
is interconnected with...
Drive_1, r2090: Bit7, BO: PROFIBUS PDA1 receive bit–serial: : Bit 7 (0=Out/1=In)
0
r2105[0] BI: 3. Acknowledge faults
0
Execution
9 Drive Commissionin
g
(
SINAMICS
)