Siemens Sinumerik 840DiE sl - Inserting the 840 Di Sl Rack

01/2007
6.3 Creating a SIMATIC S7 project
6-142
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) -- 01/2007 Edition
6.3.4 Inserting th e 840Di sl Rack
The 840Di sl Rack contains the already partially preconfigured components:
S SINUMERIK 840Di sl PLC
Standard designation: PLC 317--2DP 2AJ10
S MPI/DP interface
Standard designation: MPI/DP
S PROFIBUS DP interface
Standard designation: DP
S SINUMERIK 840Di sl NC
Standard designation: NCK 840D sl
S SINUMERIK CP for Industrial Ethernet TCP/IP
Standard designation: CP 840D sl
The 840Di sl Rack is located in the hardware catalog under:
Profile: Standard
SIMATIC 300 > SINUMERIK > 840Di sl > 840Di sl
Use the right mouse button to select the 840Di sl Rack and drag it to the Station
window, while holding down the mouse button. When you release the mouse
button, the 840Di sl Rack will be inserted in the S7 project.
HW Config -- [SINUMERIK (configuration) -- -- SIN840Di sl]
Default
840Di s l
Profile:
SIMATIC 300
C7
CP--300
CPU --300
FM --300
IM --300
M7 EXTENSION
Gateway
PS--300
RACK--300
SM--300
SINUMERIK
840Di s l
840Disl PLC317--2DP _2AJ10
SINUMERIK 840Di s l
Station Edit Insert Target System View Tools Window Help
Search:
Fig. 6-5 HW Config: SINUMERIK 840Di sl Rack
Notice
Even if the MPI/DP interface (X102) is not used, at least the the MPI
communication must be parameterized for this interface. See Section 6.3.7,
Page 6-145.
Inserting the
840Di sl Rack
6PLCComm
i
s
s
i
on
i
n
g