01/2007
8.6 DP slave: MCP 310
8-197
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
1 2 3
SHIELDM24 P24
Fig. 8-12 Connection overview: Power supply X10
For a detailed description of the electrical and mechanical design and of the
machine control panel interfaces, please refer to:
References: /BH/ Operator Components, Manual
Section: Machine control panel MCP 310
After the MCP has been electrically connected, all LEDs on the front side of the
MCP flash until communication is established between MCP and PLC.
Simultaneously pressing the two keys ”Feed stop” and ”Feed enable” (in the
bottom right corner) displays the version number of the current software version
using the LEDs now lighting continuously.
Version number = V ”Number of lit LEDs on the left LED block”
.
”Number of lit LEDs on the center LED block”.
”Number of lit LEDs on the right LED block”
In the example (Fig. 8-18) version number: V 01.02.00 is displayed.
1st digit
left LED block
2nd digit
center LED block
3rd digit
right LED block
Enable software version display
(press both keys
simultaneously)
Fig. 8-13 MCP 310 front panel
Display of the
software version
8 PROFIBUS DP Communication
To Next Page
Loading...
